Before installation please read Section 1.5. Included with the leak detector are the following items.

Please check your inbox, and if you cant find it, check your spam folder to make sure it didnt end up there.

It is the responsibility of the user to carefully read and strictly observe all safety precautions described in this chapter and throughout this Technical Handbook.

The Protec P3000 must only be operated in the proper condition and under the conditions described in this Technical Handbook.

Adress any further safety, operation and or maintenance questions to our nearest office.

Operation of the Protec P3000 with the ground conductor unconnected is not permissible.

Test samples need to be disconnected from electricity before leak testing.

For this, please refer to the information given in the responding chapters.

The clearance at the rear must be no less than 10 cm (4 in.).

Moreover, the Protec P3000 handles for carrying the leak detector at the sides of the main unit must not be covered at any time as these acts as air inlet and outlet.

Avoid the presence of heat sources in the vicinity of the Protec P3000.

However, we recommend that you carefully read the Technical Handbook to ensure optimum operating conditions right from the start.

This handbook contains important information on functions, installation, start-up and operation of the Protec P3000.

Sections marked as for Protec P3000XL only always apply to the Protec P3000XL with the SL3000XL sniffer line (capable of HIGH FLOW mode).

It may be used to localise and quantify leaks in test samples if there is helium under an overpressure within the test sample and when searching the test sample with a sniffer probe from the outside (sniffer method).

The use of this sniffer probe is mandatory for proper operation and it is available as an accessory (Cat.

No. 525-001 to 525-004).

It is able to detect leaks at a much higher distance from the potential leak at reduced sensitivity but can be switched back to normal flow at increased sensitivity.

In order to use both flow modes (high and low) it requires the use of the SL3000XL sniffer line.

It may also be operated with the normal SL3000 sniffer line, in this case the high flow mode is disabled, however.

Actual flow may vary with increased altitude and low atmospheric pressure.

If it is contaminated also indicate the nature of the hazard.

INFICON must return any equipment without a Declaration of Contamination to the senders address.

The contaminated product will be dispatched in accordance with the applicable regulations.

If any damage is discovered please immediately inform the forwarding agent and the insurers.

If it is required to exchange the damaged part please contact our orders department.

Before installation please read Section 1.5.

Included with the leak detector are the following items.

Manual For Ativa At-P3000